Anyone have a DIY for changing the plug wires on a cb360?

[JonnyLong]

I want to change the plug wires on my cb360

I'm going to use: http://www.lowbrowcustoms.com/index.php?l=product_detail&p=339#

Has anyone posted a step by step?

 

[ProSimex]

Look at the wires you have on there and try to replicate it..

 

[skatetheame]

If they are the stock coils then you can't cange the wires out

 

[nateridesbikes]

If they are the stock coils then you can't cange the wires out

this^

 

[JonnyLong]

Yes, stock coils...
But does anyone know a site where I can get aftermarkets?


Sent from using Tapatalk

 

[nukem1r]

You can swap the cables. You just have to crack the top edge of the coil off replace the wire and epoxy it in. I haven't done it but I know I've seen some type of writeup on it here I think. Good luck

 

[cafePete]

Yes it is possible with the stock coils
About 1 1/4" from the left of the coil drill down slowly,
you should start seeing were the wire is soldered to the coil, unsolder the old wire and pull
it out. Strip the end of the new plug wire, force it in from the opening, resolder, fill the hole with epoxy.
Here's a photo to help with the bad instructions.
Hope it helps

 

[JonnyLong]

Perfect! Exactly what I was looking for, You can't mess up instructions that simple..........
BUT JUST IN CASE,
Does someone want to post a few sites with after market coils? Maybe something I don't have to mod just to bolt up to this beast.




P.S.
Check out my classified adds on the site I'm going to have to put off the xs650 bobber project for a while I'm buying a new home.. Hint*

 

[ProSimex]

see that banner at the top if the page for dcc-hint*

 

[kMoto]

I don't know if those plug wires would fit in Dyna coils or not. I run the Dyna coils on my 360 and they're BAD ASS. Like these...http://www.dimecitycycles.com/vintage-cafe-racer-caferacer-bobber-brat-chopper-custom-motorcycle-electronic-ignition-parts-dyna-high-performance-ignition-coils-618-763.html

Another option are the universal 12v single lead coils like these...
http://www.dimecitycycles.com/vintage-cafe-racer-caferacer-bobber-brat-chopper-custom-motorcycle-electronic-ignition-parts-universal-12-volt-ignition-coil-24-71512.html