Back in black, a cb360 story.

[brewtown16]

By some form of miracle, i am back into bikes.... The better part is that I bought the bike I sold some time ago, and once again it has come into my posession. The bad part is that its worse off than when I sold it to him.

Theres a lot to do. I think the best part is when I left the scene there wasnt much in the way of parts, we had to fab and chop a large amount. Ive already planned on emptying my wallet to DCC.

Here she lies, dumping gas n oil everywhere.

The plans:
Already have the fabled Sonrier building a custom loom, full LED conversion.
Battery relocation/ chop the tray
Clean up the seat, have it uhplostered
Find a cl360 pipes for highside exhaust.... This will be hard!
New tires, avon am26's, or bridgestone battleaxs.
Replace and inspect jugs,valves, ect.
Fork seals are blown
New brake pads and have the rotor turned
New points and coils
Bike will run, but dies when off the throttle... Wont idle. Idle mix knob has no affect, maybe bad idle screw?
Might do mikuni cnversion from DCC
Uni pods


This will be expensive.....

 

[brewtown16]

I have new fork seals, and an engine gasket set in my possession, and a carb rebuild kits ordered.

With the above tires, any suggestions? I'm heavily considering the AVON'S since so many use them around here.

 

[brewtown16]

Decided to take a chance and bought shinko 712's. A buddy of mine runs them on a cb450 with magwheels, so I have no idea if these will work with tubes. Should be here in a few days.
http://motorcycle.motorcycle-superstore.com/search#w=Shinko+712

Bought headlight ears and a 4 in 1 speedo from DCC.

Its going to be like christmas in the brewtown household!

 

[VonYinzer]

The 712s will work fine with tubes, and are terrific tires for the money.