I thought I took pictures but the phone has nothing. Epic fail on the front lifts. So I got some time on Sunday afternoon to look at and install the lifts. Started on the backs because if they didn't fit I'd stop. They worked, I had to trim the inner ring as it was the wrong diameter but the outer was good and they fit perfect in the perch. I'll get pics of those. So encouraged by that, I moved on to the fronts. Did the drivers side first, it went in fine like I figured it would. I was able to get it all in and there was a nice gain in clearance. moved over to the passenger side and this is where it all went south on me. I got the kit installed, then it seemed to take forever to get the strut bolts lined up to get it in place, fought those, got them in, tighten up the top (I thought I did anyway) time for a test drive. could feel the increased height for sure, It's easier to get in and out. first pothole and bang, shit, loose strut, passenger side. pull in, tighten down, looks good, test drive, bang! fucking loose again. Back in garage, now I can't tighten as the coupler nut is out of the strut hole? WTF. that means the whole thing collapsed??? So I give up as this took from about 6PM till 11:30. So got up this morning, fresh eyes, pull the whole thing apart, it looks fine??? so in it goes again, put the weight of the car on it and up pops the nut again so can't make it tight, Fuck??? how one side can work and the other not baffles me, I put the rubber bit in the vice and tried to compress it, and it would compress at all so IDK WTF is going on. Sucks to cause the ride height was perfect.