Bar end signal?

[lhemrick]

I have removed the stock signals and installed a set of bar end signals on a 1970 cb350k. With only the one set of lights they won't flash unless you reconnect the rear ones (which I don't want). I admit that I'm not the smartest when it comes to electrical issues so how do I fix this?

Thanks!

 

[Big R]

You need a electronic turn signal relay. They sell them at most auto parts stores, but check out the ones made for LED lights at www.superbrightleds.com too.

 

[lhemrick]

Thanks I knew it would be something simple!

 

[two-smoker]

You can also pick up some resistors at any auto parts store, used for installing LED lights. You just wire them in place of a signal.

 

[Big R]

You could......but resistors can get pretty hot with constant use. As in too hot to touch by hand. That's why I never recommend them.

 

[Rich Ard]

Also they negate the benefits of the LEDs.

You can use an EP-34, available at Autozone, etc. You may have to run a ground if you aren't already using a three-prong flasher.

 

[lhemrick]

Got myself an EP34 electronic flasher today at Advance Auto and installed it. Worked like a charm! Thanks fellows for the help!

Lynn

 

[Rich Ard]

Pics or it didn't happen

 

[lhemrick]

OK it happened! Almost ready to make it look pretty!

 

[Rich Ard]

Lookin' "Hella" good there, lhemrick.