killerbanjo
Poor English kid getting into bikes and loves it!
Hey there, I'm currently rebuilding a 163fml Chinese motor (A cg 125/200 clone) where one of the gearbox bearings have popped. Its a needle roller (HK1712) that is 17x23x12mm. The only thing is the shaft the bearing should go into is 15mm and not 17mm. When I split the cases I was VERY careful, laying everything on a sheet so if anything fell it would have been caught, but I have not been able to find a bush. Here is a picture of the gear shaft (far right)
And here is the bearing (taken just after I split the cases to show damage)
If anyone think there should be some sort of bush or that I am missing something please tell me! I believe this is the same layout of many Honda singles which might help.
Sorry about the nooby question but first time I have split a crankcase before - Edward.
And here is the bearing (taken just after I split the cases to show damage)
If anyone think there should be some sort of bush or that I am missing something please tell me! I believe this is the same layout of many Honda singles which might help.
Sorry about the nooby question but first time I have split a crankcase before - Edward.