sbaugz
DTT BOTM winner
So, I am getting rid of the starter and solenoid on my 75 c200t, and am still using a battery with kick only start. I have read and re-read over the wiring diagram multiple times and was looking for some guidance.
So there are four wires coming off the starter solenoid:
1) heavy gauge red wire that goes directly to battery positive terminal
2) heavy gauge black wire that goes to starter
3) small gauge yellow and red one that goes to starter button switch
4) small gauge black wire that goes to who knows where ( I have since forgotten where this goes)- Its got a short 6 inch long segment of wire coming off starter with a washer type ending on it - kinda like a ground
what confuses me is that the wiring diagram shows that there are supposed to be 2 additional wires (6 total) coming off starter solenoid. (a red one that goes to ignition and a red/white one that goes to rectifier). I am not seeing these 2 additional connections. Also, the wiring diagram says that the small gauge black one listed above (number 4) above is supposed to go to the blinker relay.
So basically I am confused as to how to proceed to get rid of the starter solenoid.
Any help would be appreciated.
So there are four wires coming off the starter solenoid:
1) heavy gauge red wire that goes directly to battery positive terminal
2) heavy gauge black wire that goes to starter
3) small gauge yellow and red one that goes to starter button switch
4) small gauge black wire that goes to who knows where ( I have since forgotten where this goes)- Its got a short 6 inch long segment of wire coming off starter with a washer type ending on it - kinda like a ground
what confuses me is that the wiring diagram shows that there are supposed to be 2 additional wires (6 total) coming off starter solenoid. (a red one that goes to ignition and a red/white one that goes to rectifier). I am not seeing these 2 additional connections. Also, the wiring diagram says that the small gauge black one listed above (number 4) above is supposed to go to the blinker relay.
So basically I am confused as to how to proceed to get rid of the starter solenoid.
Any help would be appreciated.