tahitianrider
Been Around the Block
Well, I might give soldering a try then, and if not sucessful, use JB Weld.
I do have a small butane lighter/torch which should be perfect for heating up the tube before applying solder with my soldering iron. I do have electronics flux and solder. But can't seem to find plumber flux and solder here in France, or I have no idea how they call that in french...
As for cleaning the tube, I think I'll just use my dremel with a copper brush on it, and then put the bowls in my ultrasonic cleaner which make a great job for cleaning fuel residues.
Hope this is easier than soldering PCB boards which I'm no very good at lol
I do have 2 bowls with long cracks that are about 3/4 of the lenght of the tube.
Forgot to mention that fuel here does not have ethanol in it, well at least I always use the more expensive one without ethanol in all my bikes
I do have a small butane lighter/torch which should be perfect for heating up the tube before applying solder with my soldering iron. I do have electronics flux and solder. But can't seem to find plumber flux and solder here in France, or I have no idea how they call that in french...
As for cleaning the tube, I think I'll just use my dremel with a copper brush on it, and then put the bowls in my ultrasonic cleaner which make a great job for cleaning fuel residues.
Hope this is easier than soldering PCB boards which I'm no very good at lol
I do have 2 bowls with long cracks that are about 3/4 of the lenght of the tube.
Forgot to mention that fuel here does not have ethanol in it, well at least I always use the more expensive one without ethanol in all my bikes