CB360 head and cam

[oathamm]

Hi all,
Sad day for me, stripped the engine and sadly the head and cam are fooked so on the hunt for replacements if any one has any they want to off load.
Thanks
Matt

 

[oathamm]

...also this is a European model G5, were all engines in the various CB360 variants the same i.e. would the head off a 360T fit my 360G5
Thanks

 

[oathamm]

Do you think any of this is salvageable?

Worn rockers (bottom left)



Shredded cam shaft



Shredded cam seat, same damage on end which leaves cam unseated



Shattered rings, bit unclear in this pic

 

[Sonreir]

Difficult to see from the pics, but are you sure it's toast? It looks a little worn, but I've seen worse.

 

[oathamm]

Thanks for taking the time to look, this is my first build, I thought the middle cam bearing and journal would be ok but the ends are worn as well which creates a lot of lateral movement so I'm guessing that would throw the cam out and eventually lead to more issues. I've ordered some replacement parts now so hopefully they'll be in better condition and will fit! Fingers crossed. Cheers

 

[Sonreir]

Lateral movement happens. They make various sizes of thrust washer available just for this purpose.

 

[motorguy]

I can rebore the camshaft tunnel and reface the rockers..the cam can be machined as well..Just not sure how much a good used head would cost .That mite be cheaper..I have machinery to redo the piston skirts to.