CB360 idle

K

Kain

Been Around the Block
Hey guys.

My 360 Idles really low and sputters out sometimes. At times the only way I can keep it running is by keeping my hand on the throttle twisted just a tiny bit. Will the idle screw be the right thing for the job? If so... which one is it? I have a shop manual but couldn't really decern which one it was.

A pic would help :)
 
Kain said:
Hey guys.

My 360 Idles really low and sputters out sometimes. At times the only way I can keep it running is by keeping my hand on the throttle twisted just a tiny bit. Will the idle screw be the right thing for the job? If so... which one is it? I have a shop manual but couldn't really decern which one it was.

A pic would help :)
Click to expand...

Yup. The idle screw is on the left side of the bike, on front most part of the carbs. Just play with that until you get a good idle speed.
 
Well didn't get to it at lunch. Cause I had an other question.

What RPM should I be running at while it's idling?
 
Kain said:
Well didn't get to it at lunch. Cause I had an other question.

What RPM should I be running at while it's idling?
Click to expand...

Mine runs about 1300-1500, but I need to sort the carbs a bit better, cause they ain't sync'd.
 
i get some idle problems too, but its only when the humidity has been dropping or raising really high, fluxuates about 300rpm. not much, but it bothers me. i dont know why it does that though....
 
mine usually runs a bt high at 1500-1700, but then it wants to die after it gets warmed up. does one turn it up more at cold so it right after warm up?
 
You must log in or register to reply here.

DTT Light or Dark

  • DTT Light
    • www.jadusmotorcycleparts.com
    www.lostapostle.ca/
    www.sparckmoto.com

    Spread the Love

    Back
    Top Bottom