Got some goodies and made a little more progress.
Finally ordered my caliper, but in order to get the right clearance I need to build a spacer between the disk and hub. About 6mm is required to make the disk center in the caliper. The caliper does not float. I am going to machine down an old disk carrier I have laying around. Also got the master cylinder (11mm Brembo with a brake light switch) and measured up the line length I need.
Built the headlight bracket and mounted it up, also knocked out the blue lens on the Bates style light and added a mini toggle switch to operate the headlight. Going for a clean bar look and should only have one small button for the horn and no other crap aside from clutch, throttle and brake.
Maybe I went crazy, but I could not resist the Motogadget tiny speedo! Also, got the rest of the stuff to wire the bike up, including a combo regulator/rectifier and the 4 cell antigravity battery. Next step will be to make a place to house this stuff along with the electronic ignition module.
Last, I think I found a muffler that will work and I am going to run a 2 into one using this Kerker k series. It is rough, but ima going to clean it up, re-pack it and shoot it black with the rest of the exhaust. Oh, and my rear sets are on, just need to trim the plates to make them look nice and get the rear brake working.