CB550 rotor drilling

diesel450

"Fast with a past"
DTT BOTM WINNER
Anybody got a template for drilling a CB550 rotor? I can't find anything on the interweb, just 350/360 stuff.
 
How about some graph paper?? Place an intersection of a graph at the center of the disk, tape the paper to the disk with double sided tape, trim the edges and then make up your design.
 
Geez man that sounds like a lot of work and shit. :) I found a usable one though. Thanks, good idea if you can't find one or a pattern you like.
 
Back
Top Bottom