fluke12
Been Around the Block
OK, so I've been working on my turn signals, I replaced the fronts with LEDs and the rear with an led tail light/turn signal strip from custom dynamics (Custom Integrated 3 Section TruFLEX, about halfway down the page) . I also got a LED flasher Relay to help with the whole, not blinking thing. So now the turn signals are blinking, they just all blink at the same time. If i plug in a standard set of turn signals in the rear, it works properly. The relay says it works from .05A to 10A loads, so I assumed that'd be enough to do what i wanted, but apparently i still don't have enough resistance in the line to get it to only flash on one side?
Anyone have any advice? I've heard talk of capacitors or a few other things that might help. any advice on what to do and sizes of things/where they go, if i need to wire them in line. I wanted to save power, but i have plenty of battery strength (antigravity 8-cell battery), so i may negate them being LED which is fine, i just want them to work properly.
Big thanks for any help
Anyone have any advice? I've heard talk of capacitors or a few other things that might help. any advice on what to do and sizes of things/where they go, if i need to wire them in line. I wanted to save power, but i have plenty of battery strength (antigravity 8-cell battery), so i may negate them being LED which is fine, i just want them to work properly.
Big thanks for any help