CL350 Swingarm Bushings

[Gweenz]

Hi everyone, started on a 73 CL350 project earlier this month. I'm getting some bronze swingarm bushings made for me, and I was wondering if anyone has the measurements for these? Thanks!

 

[Big R]

I don't have the measurements, but is there a servicable limit mentioned in the manual?

 

[Gweenz]

Rear fork pivot bushing:

Standard Value:
20.000~20.033 (.787~.789)

Replace if over:
20.18 (.795)

From page 79 of the Honda shop manual

 

[crazypj]

Your looking for dimensions to make some, just press out the originals to measure outside diameter and length then measure the pivot bushing for inside diameter.

 

[Gweenz]

Pressing them out will be difficult. Hacksaw might be my only option...

 

[Rocan]

im not sure on dimensions but if you go over to http://www.hondatwins.net/forum/viewtopic.php?f=21&t=448&p=43272&hilit=bronze+swingarm+bushings#p43272 and sign in/register, then post in the thread, we might be able to get that guy to produce a set.

 

[Gweenz]

Looks like he is out of town for a while =/