cl360 rubber tubing/lines question

[Distanceham]

I'm hoping to make one last order of parts for my rebuild (for now). I mistakenly threw away all of the fuel lines, carb tubing, what else am I missing, etc. I can't seem to find the correct diameters and length of tubing needed. What do you all recommend/ what does Honda use? Any suggestions/modifications would be welcome. The only change I'm planning on making at present is the 2 way EZ disconnect for under the fuel tank.

Thanks

 

[mydlyfkryzis]

Standard fuel lines are 5.5 MM..Slightly smaller than 1/4 inch ID, slightly larger than 3/16 id.

Honda still sell the fuel line, ethanol resistant now too.

I was using 1/4 but found it a little unreliable , even with a clamp. I went to 3/16 as it stays on without a clamp, but I still but a clamp on.

I tried Tygon line, but found it softens and swells in todays gas.....

 

[Sonreir]

Really? I've been running Tygon for two years now and I quite like it. E10 here in Oregon.

 

[mydlyfkryzis]

Really? I've been running Tygon for two years now and I quite like it. E10 here in Oregon.

I bought the tygon specifically because it is supposedly good in 10% ethanol. But after about 2 months, they had swelled and slip easily of the petcock nipples.

I may try a different supplier....It was a small motor shop on e-bay....maybe it wasn't really tygon. I bought about 6 feet of it, and was disappointed at the swelling. It looked nice, but didn't do the job...