CMX400 IGNITION COIL? ARE THE WIRES HARD WIRED OR CAN i REPLACE EM?

[Eastcoastmod]

Hi all

I noticed that the wires were getting a little ripe at the spark plug end. Can I remove the wires from the coil end or are they hard wired? I didn't want attempt to twist off or pull not knowing. The coil appears stock.

Thanks in advance for the help. I have sucked a lot of usefull information from this site.
\
Colin

 

[bjonesin]

Parts fische shows them as being attached. I've seen cb750 threads where people dremel cut open their coils and splice in new wires,so what you're asking can be done.

I believe the plug caps can be changed as well, without having to replace the entire wire.

Sent from my DROIDX using Tapatalk 2

 

[Eastcoastmod]

Sounds like work . Replacing the caps sounds like the way to go. It's at the plug end where things are ripe. I'll give it a try. Thanks for the help.

Colin

 

[mydlyfkryzis]

Dime City Cycles has these splicers. You could cut the wire shorter, splice in some new wire...I'd put new caps on too...they are relatively cheap.

http://www.dimecitycycles.com/vintage-cafe-racer-caferacer-bobber-brat-chopper-custom-motorcycle-electronic-ignition-parts-ngk-inline-spark-plug-wire-connector-207-120.html

 

[Eastcoastmod]

Thanks again.

Unfortunately I don't seem to have a lot of spark at the moment. Could be another issue.