erock85
Been Around the Block
I too am working on a comstar to CBR front end. Here's what I have currently
Here's a cross section of the wheel/hub of the comstar and the colored components are what I need to machine. Spacers and such. The blue section is the bearings, also went with 9mm and the fuschia is the bearing dust seals. Red is the spacers. And green is the axle collar. The rotors I used have an offset of 12.5mm so I had to take that into consideration when I designed the hub rotor adaptor.
Here's a cross section of the wheel/hub of the comstar and the colored components are what I need to machine. Spacers and such. The blue section is the bearings, also went with 9mm and the fuschia is the bearing dust seals. Red is the spacers. And green is the axle collar. The rotors I used have an offset of 12.5mm so I had to take that into consideration when I designed the hub rotor adaptor.