SquidHunter
Been Around the Block
Ok guys, long time no update. I finally bit the bullet and buckled down on the Honda. Completely reworked the wiring. Took my time and did it right. Soldered all the connections and everything. Bike fires up first try and rides amazing. Here’s the kicker: same exact problem! After the motor gets good and heat soaked, the ignition fails and I’m getting no spark. After it cools down, fires back up and runs good. I’ve been riding with a laser thermostat in my pocket because of this. It seems to fail when the ignition model reaches 145 degrees. Then restarts when it cools down by 20 degrees.
I called Gary at power arc, and explained the situation. I’ve literally tried everything from diodes, colder plugs, even a 200 dollar mosfet regulator. Always the same problem, and even weak spark on cylinder one most of the time.
Today I shipped it to him for further testing. He says he can make it right. So far I’m super disappointed with the whole situation. I’ve spent almost as much on this as I paid for the bike
Sent from my iPhone using DO THE TON
I called Gary at power arc, and explained the situation. I’ve literally tried everything from diodes, colder plugs, even a 200 dollar mosfet regulator. Always the same problem, and even weak spark on cylinder one most of the time.
Today I shipped it to him for further testing. He says he can make it right. So far I’m super disappointed with the whole situation. I’ve spent almost as much on this as I paid for the bike
Sent from my iPhone using DO THE TON