trying to wire up new DYNA 5ohm Single output coils for my CB350 (new points, new condensor too)
there are 2 terminals on the coils...
The included instruction say
"One the single output coils, the primary terminal opposite the side with the output tower has a + marking. Plus 12volts from the ignition switch is applied to that terminal"
there is no + marking on the coil anywhere, from reading the above I am assuming that power goes into the terminal that is on the opposite side of where the plug wire comes out??
The UPPER terminal in the photo below ???
there are 2 terminals on the coils...
The included instruction say
"One the single output coils, the primary terminal opposite the side with the output tower has a + marking. Plus 12volts from the ignition switch is applied to that terminal"
there is no + marking on the coil anywhere, from reading the above I am assuming that power goes into the terminal that is on the opposite side of where the plug wire comes out??
The UPPER terminal in the photo below ???
