ground cb360 coils

[blueandy]

started a new wire harness. so far so good. but when i went to kick through to see if the coils are getting fire, they werent. now arent the cb360 coils supposed to have a ground? must have pulled it off when i pulled the stock harness off. anyway, can anyone help me out on this? looking at the stock coils with their respective leads i cannot for the life of me find where a ground would go. i specifically remember a green wire by the coils with a bolt clamp attached to it.

 

[SONICJK]

They should ground through the mounting.

 

[blueandy]

i guess i shouldve asked where the does the ground off the mount go? Sorry didnt word the question correctly. i have the ground wire with the bolt hole mounted but where does that end off the frame go? cant figure out where it goes once i mount the ground to the frame. does that make sense?

 

[SONICJK]

I guess you could ground the mount to that bolt. I just take off paint under the mount so it grounds itself.
This is on a 350 I assume the 360 is the same.

 

[crazypj]

The front left bolt hole wasn't painted from factory and ground wire went underneath coil mounting