Im working on a set of CB350 carbs and I am having a hell of a time setting the float height. This isn't my first rodeo, im not sure why im having such issues. Here is a pic of how I am measuring. Carb tilted just until the float notch rests on the needle, before it starts to compress. Measured from the carb body to the top of the float.
According to the manual, floats should be at 19mm. However, I cant even get the float down to 19mm.. it bottoms out on the carb at 19.21
Here is where it looks more like a normal resting place.. comes out to almost 25mm
WTF am I doing wrong? I have a second set of 350 carbs, but I run into the same exact issue with them. (wifes hands, not mine)
According to the manual, floats should be at 19mm. However, I cant even get the float down to 19mm.. it bottoms out on the carb at 19.21
Here is where it looks more like a normal resting place.. comes out to almost 25mm
WTF am I doing wrong? I have a second set of 350 carbs, but I run into the same exact issue with them. (wifes hands, not mine)