Hello All. I'm new here and have an issue. I've searched the forums and haven't seen a similar problem so here goes.
The PO cutoff the brake pivot on my Honda CB360 I didn't realize this until after I started putting it together (this is my first build). So now I need to figure something out. At this point I'm thinking of just running a rod from the brake arm directly to my rear set, but I would rather run it with a brake pivot - since brake bump doesn't sound optimal.
Has anyone fabricated a brake pivot that could be welded to the CB360 frame and can offer some advice on the best way to do this? TC Bros has a forward control pivot that can be welded, but the geometry isn't exactly right for rear sets.
Any advice would be appreciated. Cheers.
The PO cutoff the brake pivot on my Honda CB360 I didn't realize this until after I started putting it together (this is my first build). So now I need to figure something out. At this point I'm thinking of just running a rod from the brake arm directly to my rear set, but I would rather run it with a brake pivot - since brake bump doesn't sound optimal.
Has anyone fabricated a brake pivot that could be welded to the CB360 frame and can offer some advice on the best way to do this? TC Bros has a forward control pivot that can be welded, but the geometry isn't exactly right for rear sets.
Any advice would be appreciated. Cheers.