Honda Dream 150

[kneedragger74]

Does anyone know if the Honda Dream 150 shared the same carb with any other bike. I am having a very difficult time locating a carb that will fit. Also, If anyone knows where I could pick up a shop manual for rebuilding the Honda that would greatly help, as most of the bike seemed to be out of sorts when it was dropped off to me.

 

[Big R]

Have you cross referenced the part number on bikebandit.com yet? It probably wont be an exact match though. Might have to measure the intake diameter and mounts and look for a similar carb.

 

[kneedragger74]

Thanks, Rich. I'll give that a shot!

Dan

 

[Tim]

Do you not have a carb at all? I have a complete parts bike, including the engine in 3 boxes (literally every single nut and bolt out of it - basically scrap metal). There may be a carb in there somewhere.

 

[kneedragger74]

Do you not have a carb at all? I have a complete parts bike, including the engine in 3 boxes (literally every single nut and bolt out of it - basically scrap metal). There may be a carb in there somewhere.

No, I bought it without the carb. This one probably should have been a parts bike too, but I have always liked them, and really want to get it going. I am also looking for the upper and lower chain guards, handle bars, etc... Let me know if you have anything you would be willing to part with. Thanks a million.

Dan

 

[Tim]

I'll dig through the bins. Not sure the bars are going to be much use, but I might have an upper chainguard (the bike itself is out at a friends place - I'll get him to snap a pic of it for me tonight to confirm what's on it). Lower chainguards are tough to find - they always rusted through.

 

[Slice]

I have an extra carb from a CA77 Honda 305 dream, will it fit?
Lower Chain Guards +1... very very hard to come by and if you do, open the wallet up.
Also try this site: www.honda305.com/forum
-Slice

 

[kneedragger74]

Thanks, guys... Any and all help is greatly appreciated!