Honda Generator Puller

[Frankmowthelawn]

What size is the thread of the Honda Generator Puller?

Thanks in advance!!

FMTL

 

[frogman]

Which bike? The rear axle on my 360 fits perfectly. Might check yours.

 

[jay_kent]

18mm for my cb650. I used a spark plug re-threader and an impact gun.

 

[hond cb350e]

you need a rotor/flywheel puller 16mmx1.5 RH ,motorcycle sollutions LLC.com has them

 

[Rocan]

z1 enterprises also has one.

you can use the rear axle also.... a bit of a PITA but works if you dont have the tool. keep the spacers on there and use the whole axle as a slide hammer. it will come off... eventually.

 

[Frankmowthelawn]

I was just thinking that the right size bolt would push the stator right off and if it is a standard thread (16mmX1.5 sounds pretty standard) I could get one and not have to buy the Honda unit. If it needs help a threaded hole in the center with an allthread to push with would do quite nicely.

Thanks again!!

FMTL

 

[frogman]

Easy way is thread the bolt in tight then as you turn it smack the bolt head with a hammer and it will prolly pop right off.

 

[Frankmowthelawn]

Cool! That's even easier!!!

FMTL