How to connect plug boot and coil wire?

N

Ncstatecamp

Been Around the Block
Taking out my motor (Hyosung gv250) and the wire and boot are no longer connected. Looking online to buy a new ignition coil the pictures show it without a boot. Anybody know how these would connect?
 

Attachments

  • ImageUploadedByTapatalk1361747531.333353.jpg
    ImageUploadedByTapatalk1361747531.333353.jpg
    212.7 KB · Views: 359
Look inside the boot. There's a sharp pin protruding. When you push the wire into the boot, that pin will pierce the copper core of the the wire. Push the wire into the boot and twist until its seated.
 
Re: Re: How to connect plug boot and coil wire?

VonYinzer said:
Look inside the boot. There's a sharp pin protruding. When you push the wire into the boot, that pin will pierce the copper core of the the wire. Push the wire into the boot and twist until its seated.
Click to expand...

Yep, a lot of them are even threaded so you basically "screw on" the boot. No problemo.
 
You must log in or register to reply here.

DTT Light or Dark

  • DTT Light
    • www.jadusmotorcycleparts.com
    www.lostapostle.ca/
    www.sparckmoto.com

    Spread the Love

    Back
    Top Bottom