i need a good machinist...

[Gilligan]

i just picked up a 92 zx7 inverted front end and i need help machining the neck stem down to fit in my 77 xs650 neck.

i also plan on using the rear wheel ,which means im going to have to get an offset sprocket up front so the chain will clear the tire.

thirdly i have a blank rear sprocket i need machined to fit the rear wheel as anything offered for the xz7 wheel will barely allow me to reach highway speeds.

any help is greatly appreciated!

thanks,jeff

 

[Krixxer]

local? try KMM " the machine shop dealers use" Peter or Doug 905-564-7748

I don't know these guys all that well but when I moved into my shop across the street I dropped by to offer them my painting services and noticed they have a well equipped machine shop in the back.

 

[DrJ]

Hey man, try:

Gord Bush Performance
(416) 259-9700
49 Fima Cres
Etobicoke, ON , M8W3R1

This is the guy I get to do my stuff but he's in Guelph.

http://ritepricemachining.com/

 

[Gilligan]

Hey man, try:

Gord Bush Performance
(416) 259-9700
49 Fima Cres
Etobicoke, ON , M8W3R1

This is the guy I get to do my stuff but he's in Guelph.

http://ritepricemachining.com/

thanks j. ill check with them on monday.

do you remember at timmies last year there was a guy riding an xs who said he was a machinist? he also said he was on here?!?!

 

[jay_kent]

Hey man, try:

Gord Bush Performance
(416) 259-9700
49 Fima Cres
Etobicoke, ON , M8W3R1

This is the guy I get to do my stuff but he's in Guelph.

http://ritepricemachining.com/

He's actually no more than 10 minutes from my house. I'll have to keep him in mind. thanks

Jay

 

[Tim]

Gord Bush is a great shop - I had my XS650 work done there. Bored the cylinders and did a valve job for me. Also blasted the snot out of the parts to get layers of black spray paint off them.

I've also used Concepts on Wheels up in Markham - did my CB550 rebuild there.