When i picked up my hardtail project a few random wheels were incuded: 2-21" and 1-16" which i picked up strictly because they were 40 hole rims that i was planning on lacing onto my stock honda hubs via some custom spokes. Now, as it turns out the rear wheel has a stock 20mm axel diameter so it'll fit right into the frame without too much modification.
The issue is that the 16" hub (actually none of the hubs..) have the part of which houses the brake pads - it's just a big gaping hole.
Does anyone know how i'd go about identifying the hubs so i could get my project rolling(and stopping)?
The first 21" pictured has a hub which is larger on the brake pad side than the non brake pad side while the last one pictured is more or less a chunk of pipe used as the hub - same size from one side to the other. I was told the last hub was something special but have no idea why.
Can anyone help me get these things complete?
The issue is that the 16" hub (actually none of the hubs..) have the part of which houses the brake pads - it's just a big gaping hole.
Does anyone know how i'd go about identifying the hubs so i could get my project rolling(and stopping)?
The first 21" pictured has a hub which is larger on the brake pad side than the non brake pad side while the last one pictured is more or less a chunk of pipe used as the hub - same size from one side to the other. I was told the last hub was something special but have no idea why.
Can anyone help me get these things complete?