Mikuni's for CB450

[Zonda]

Hey gents the old 450nsm site had a lot of info on the jets and needle people were using in there Mikuni's :'( With this gone could someone tell me the different jets used. The engine is new and fitted with a 500cc kit running, 34mm round slide Mikuni's.  ;D
I Need the size for the Needle jet (159 series), Pilot jet, Main jet and Needle size and which ring the clips on. I know that your sizes may not work on my engine but at last i'll have a starting point.

Rod from OZ 8)

I have found these specs for 34mm carbs on a race bike not sure if this is the place to start, any advice welcome
Main Jet 220
Pilot Jet 35
Needle Jet P4
Needle 6dh2
Slide 2.5 cutaway

 

[Flugtechnik]

Although I'm sure you are aware, a lot of the guys from the 450 MSN group have moved over to hondatwins.net.  They made a 450 section on there for us.  Also, someone saved all of the old MSN group posts on a different site.  Supposedly you can search through them.  However, I can't remember where they are.  Hondatwins is blocked here at work so I can't look for it.

Unfortunately, I don't have any input for your actual question.  :-[

 

[Zonda]

Hey thanks ;D found the list and did a search found the info i was after