My CB750 Cafe Racer Seat Solution cont.

[MBS]

The seat cowl I made out of the front half of a Harley wide glide fender. It was just the right height, width and length. I bolted that through to holes I drilled in the seat support cross member part of the frame. I also used some car door trim on the edges to protect the frame and cover I will be making later. Its a two piece seat and cowl, but should look really nice and seamless once I get a cover on both parts.

 

[jfman]

I know this is an old thread but do the pics work for you guyz?

Says my computer doesn have the right picture viewer?

 

[Boner]

no

 

[MBS]

Sorry. Not sure why that is. What pics are you looking for? Pm me and I can send em over.

 

[jfman]

Pics of a tail section made with a harley fender.