Sav0r said:I don’t buy bacon anymore. It’s just too easy to make it. I usually do 10lbs at a time
I ran over my buddy's Raybans with my van in high school. He sent them in for a free new pair. I guess they don't do that anymore?The Jimbonaut said:Just an update on those TCX Drifter boots I bought last week. 500+ kms, a few trails and one biblical downpour and these things are coming up aces. No issues whatsoever, very comfortable, completely waterproof and very well made. Could not be happier.
They will however completely destroy any sunglasses left lying around in the dirt. Went to a festival this weekend - wife left her raybans lying around and I absolutely hooved the things to pieces. Destroyed.
I wish they still made the M-Frame. I've got a couple frames, and several lenses for them. 11 years in, hopefully I can get another 60 or so out of them.advCo said:They should. I wear Oakleys and after 3 years of owning my last pair, I broke the hinge on one of the arms. They covered the cost of a brand new pair, and I even got to upgrade to polarized since the price of their polarized had gone down since I bought my old ones. Win!
farmer92 said:
Cheapo slip roller
Hurco550 said:Nice! makin chambers?
farmer92 said:Ya gonna give it another shot.
My main problem was getting a proper fit when joining two sections. I could get the smaller diameter stuff pretty much round by wedging in a tapered pipe, but the larger diameter cones would leave me with a big enough gap that i couldn’t weld it without blowing through excessively.
Hopefully this helps
I just use small vice grips at one end, tack it using O/A and filler and do the same on the other end. Once that's done I put it back over a piece of pipe and hammer it flat. I then back tack every 25 to 30mm and then hammer that flat. Finally I just fillet weld with no filler and then gently hammer that flat.teazer said:To make the cones, I use two or three large hose clamps to hold the seam closed and then I tack it up without filler. with enough spots welded, I can start to stitch it up with TIG or a really small oxy nozzle. Mainly a 000 size.