SouthPaw
Been Around the Block
Well I spent a good chunk of the day tinkering with this. Fixed the LED signals that had a detached wire and I will be using those for the front. Lucky me that the signal mounts fit exactly the headlight bucket hole/ nut on the inside... So I decided to mount the turn signals there. Did some work then realized that I had to actually mount the bucket before soldering everything in place.
So back to the sunroom I went, Mounted as much as I could, hooked up all of my lights / connectors. Turned the bike into the 1st position, saw a flash of light from my Gauges, then nothing in the front. Nothing at all. The rear had a soft red glow from my tail light, but that's It.
Prior to this I pulled the tank off, Not sure if these are stock. but the second picture definitely is not stock as It was held up with duct tape.
Help identifying the controls or the " thing" in the last picture would be awesome. emailed the PO for more information, but I am calling it a night.
Thanks in advance for any help.
So back to the sunroom I went, Mounted as much as I could, hooked up all of my lights / connectors. Turned the bike into the 1st position, saw a flash of light from my Gauges, then nothing in the front. Nothing at all. The rear had a soft red glow from my tail light, but that's It.
Prior to this I pulled the tank off, Not sure if these are stock. but the second picture definitely is not stock as It was held up with duct tape.
Help identifying the controls or the " thing" in the last picture would be awesome. emailed the PO for more information, but I am calling it a night.
Thanks in advance for any help.
