Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Can I request a quick vid on the basics of setting the timing and valve clearnace? Between the Clymer and the vid Im sure anyone could do these basic up-keep procedures.
So the same basic principles apply to all twins? Just different locations for the valves. IE: One cover will expose the exhaust and intake valves and they should both be at the same gap spec right?
KZ is real easy, you can see which lobes are up and down.
Pulling off chain tensioner and removing cams isn't a big deal, usually only happens every 2~3 years unless your doing high milage.
KZ is real easy, you can see which lobes are up and down.
Pulling off chain tensioner and removing cams isn't a big deal, usually only happens every 2~3 years unless your doing high milage.
Yes, I know its an easy job on the KZ, I was just referring to the fact that you could adjust those particular valves just by turning the screw and be done in five minutes, compared to having to remove the tank, valve cover just to check them on the KZ, and then buy different shims and remove the shafts if adjustments are necessary. Considerable more effort on the KZ. Plus if you ruin the valve cover gasket you need to buy another one of those as well. The process is really simple, but its considerably more work compared to the twins.
Keep in mind that this guy adjusted his timing to the wrong hatch mark on the stator. You will actually want to align to the "F" mark. And off the top of my head, I believe on the larger honda twins (CB350/360 for example) you align the left points to the "FT" and the right side to "F"
Keep in mind that this guy adjusted his timing to the wrong hatch mark on the stator. You will actually want to align to the "F" mark. And off the top of my head, I believe on the larger honda twins (CB350/360 for example) you align the left points to the "FT" and the right side to "F"
You use whatever feeler gauges work best for your engine. They make them angled just to fit easier in the access holes, if you need that. Some are made really long too.
So if you're buying a set, give some thought to which style will reach your tappets the easiest.
In the event that you have a Honda twin, getting the tool pictured below will make your life easier. They're made by Motion Pro. One side is set for the intake clearance and the other side is set for the exhaust.
If you don't want to shell out the cash, the one suggestion I'd make is that the bend of your straight feeler gauge should be about 1 to 1.5 cm from the end of the gauge. I initially bent mine about an inch out from the end, and the angle made it tough to get a good read on the clearance.
With this motion pro tool, it is not only bent at the right spot, but it's pretty narrow as well, which enables you to lower it beside the tappet, then slide it in from the side with the gauge already at the correct angle.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.