namelesspenguin said:
I PM'd you, but I think this will give me what I need. Just wanted to double check though... chassis ground to the body of the coil mount is really the only thing not shown, correct? And I can just leave the entire R/R section out for a total loss circuit, correct? The electric start wiring is easy enough.Sonreir said:Barebones diagram for the Honda twins and singles. Only enough to get the bike running and keep it that way. No lights, signals, or gauges included. Though not pictured, I recommend a 5A fuse on the black wire leading to the coils.
timberwolffxdl said:I PM'd you, but I think this will give me what I need. Just wanted to double check though... chassis ground to the body of the coil mount is really the only thing not shown, correct? And I can just leave the entire R/R section out for a total loss circuit, correct? The electric start wiring is easy enough.
Sonreir said:If you're running without a kill switch, power going to the coils and power going to the solenoid should come from the same source.
bydgoszcz said:Thanks for the help Sonreir.
Two questions if you could help me out.
On the ignition switch(Standard Square plug) there are 4 wires, Red, Black, Brown and Brown/White. I'm know red is power and I'm assuming black is ground, what I'm not sure is which colour after that corresponds to Ignition and Accessories.
Second question, on the solenoid (New ebay one), theres two screw posts and then two wires that come out, Red/Yellow and Green/Red. Again I'm assuming that one of the screw posts connects to the battery and the other to the starter. Then the Red/Yellow connects to the starter button and the Green/Red connects to the ignition switch (Which ever colour corresponds to ignition on the ignition switch) Does this sound right?
Thanks again!
Sonreir said:Sort of.
Red from ignition switch to battery +, black from ignition switch is your power. This goes to the green/red wire on your solenoid as well as off to the ignition coils, lights, etc. Yellow/red on the solenoid goes to your starter button and then button then completes the circuit to ground.
Brown and brown/white not needed unless you want parking lights.