Throttle Issues

[Kola21]

Hi all,

I'm having issues with my throttle where it shifts on the bars and I can't for the life of me work out how to tighten it.
I'm using the stock bars and throttle.

Cheers,
Kola

 

[2b]

Sounds odd.

Does the unit that houses the kill switch, headlight switch and horn move as well? Or is it just the throttle. Is it sliding left and right? Round and round?

 

[Kola21]

The whole unit moves, it shifts left and right and round slightly only being stopped by the cable that are attached.

Its odd because i've tried tightening the screws etc

 

[orrible-64]

pin that goes into hole in handlebars has broken off. undo screws take switch block off or slide almost off handlebars. put a layer of gaffa tape on handlebar over the hole in bar , slide all back into place and tighten. should stop it slipping so bad
or dissasemble switchgear,drill a hole where pin broke and glue a short bit of wire in to replace pin

 

[Bert Jan]

I am with orrible. Prolly the lockpin

 

[Kola21]

Awesome I'll give that a go tonight
Thanks orrible!