joeschuit
Been Around the Block
I'm making some room in the shop and my fuel injection project hasn't been touched in a while. I've got this modified set of yamaha r6 throttlebodies and aluminum adpaters that would fit directly onto suzuki gt250/t350 cylinders, and would be very close on the yamaha rd bikes as well. It has a tps sensor on the side, a built in fuel pressure regulator, and is ready for a throttle cable. I do have a wiring harness made for a microsquirt that has many of the connectors you may need. I have a good fuel pump on ebay that pairs well with this setup here: http://www.ebay.com/itm/261400921590?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
I'm letting this go for $60 shipped. This will give you a serious head start if you'r traveling down the efi trail with your 2 or 4 stroke twin.
I've also got these coil near plug coils and connectors. These are usually $20 each on ebay, selling for $25 shipped, used only a few times.
I'm letting this go for $60 shipped. This will give you a serious head start if you'r traveling down the efi trail with your 2 or 4 stroke twin.
I've also got these coil near plug coils and connectors. These are usually $20 each on ebay, selling for $25 shipped, used only a few times.
