Triple Shaving

[jsharpphoto]

Is there anyone on the forum offering triple clamp welding and shaving services?

 

[sav0r]

Are you just looking to have the clamps removed?

 

[jsharpphoto]

The risers removed. I could so that myself, but I think the underside needs to be welded to support the loss of structure.

 

[jsharpphoto]

These risers are massive, and the webs on the underside look pathetic.

 

[sav0r]

Yeah, those are some pretty flimsy looking webs. I could certainly mill them off for you, but the welding would need to be done elsewhere. If they were built a little heavier we could go the route of leaving the holes shine through.

Are you concerned with take the entire riser off, or could you just settle with taking 80% off?

 

[jsharpphoto]

I have two options at this point. Either remove enough of them so it doesn't look stupid. Or have a new one machined altogether. I can get a new aluminum one cut for around $150.

I have seen several people on here with shaved and welded OEM yokes, but they were mostly 340/360/750 CB's, and the CB77 Super Hawk is a very different animal

 

[sav0r]

I'm sure it would only cost you half of that to have a local fabricator weld it up and machine those off.

 

[jsharpphoto]

That's my estimation too. I just wanted to make sure there wasn't anyone in the community that I could give my cash to.

Now, assuming the brand new cnc'd triples cost twice as much, are they twice as good?