Universal Rearset Sale. ---Updated to include bolt on kits.

[J-Rod10]

It uses a stock bolt that you already have.

It comes with:
2- Pegs/Levers
2- Linkage rods
4- Heim joints
4- Stainless button head screws and nuts
1- Shift Shaft lever
2- Brake piece pivots

 

[justin_labayen]

How am I supposed to hold the pivot assembly together? The original setup has the nut built into the the brake lever

 

[J-Rod10]

Put your pivot through frame, and send me a pic of it sticking out from the lever side.

 

[justin_labayen]

I added a picture.

 

[J-Rod10]

The part with the square hole machined in to it goes to the outside of the pivot. That situates on the stock rod Thay runs through the frame, and it is drilled and tapped for the stock bolt to secure it.

 

[justin_labayen]

Can you post pictures of what you're trying to explain? I don't see anything that's tapped

 

[J-Rod10]

That rod is different than any CB360 set-up I have seen. That rod should have a built in, slotted washer on it that the outer brake pivot bolts to.

Can you send me a pic if your stock assembly, how it come out of the bike?

I have sold a ton of CB360 sets, and I have not seen a rod set up that way.

 

[justin_labayen]

What I'm seeing is that '76 have different brake lever/pedals. Has anyone with a '76 bought from you?

 

[J-Rod10]

I couldn't tell you. I have never come across this issue over probably 1,000 of this particular set in the last couple years.

 

[justin_labayen]

I guess I'll just chop and weld the original brake lever nut

 

[J-Rod10]

If you aren't happy with them, you can send them back and I'd be happy to send you a refund.

 

[justin_labayen]

No worries. I'll make it work. From what I'm reading, '75 and '76 are different from the '73-'74.

 

[bryantr]

I just bought a set from you off instagram. Wish I had seen them on here first! Haha. Anyway I could order just linkage and pivots for my '74 cb350f? I'll need to measure the length needed for the linkage since I'm mounting them in a position different than your bolt on kit.

 

[J-Rod10]

Absolutely.

It'd be $75, and come with rods, 4 heim joints, 2 rods, shift shaft, and brake shaft pieces.

Just e-mail me the lengths.

 

[justin_labayen]

Hey J-Rod, I tried making the rear sets work but I had to sacrifice the positioning. Is there any way I can return these and get a refund? Thank you for your time

 

[J-Rod10]

Sent you a pm.

Could you shoot me a pic of what you mean by sacrificing the positioning? I'm not quite following.

 

[J-Rod10]

Have been busy with a job in my machine shop for the last couple weeks, finally wrapped it up. To those who have shot me a PM asking about these, they are available again.

 

[J-Rod10]

Bump, few more sets at this price.