unnecessary tabs cb750 doch

R

robbins

New Member
Im trying to remember if I need to keep those triangular shaped pieces on the bottom tail end of the bike. Im getting ready to grind off the air box tabs and other that are not needed and install a cafe loop and prep the frame for powder coating. Don't want to take something of that needs to stay or leave something that should go. This bike was in pieces otherwise I would have taken pics and notes.

Thanks
 
Also any help on what others have done to get there frame the way they wanted it would be great . How do I start a new build thread on this sight. Im sure its obvious and I'm just missing it.
 
depends on which tabs. some of them are for mounting side panels, etc that you may not need. some might be important. Post some good pics of your frame with the tabs visible and folks can help point out which ones are for what.
 
I can take some pics, but right now I'm specifically talking about the large triangular pieces on the rear lower. I wasn't sure if I should keep them for rear set mounting location. Looking for a close up pic of a cleaned up rear of both sides of a dohc frame.
 
those are for hanging you exhaust and your factory passenger pegs. some people use them to mount rear sets. probably don't want to cut those off
 
You must log in or register to reply here.

DTT Light or Dark

  • DTT Light
    • www.jadusmotorcycleparts.com
    www.lostapostle.ca/
    www.sparckmoto.com

    Spread the Love

    Back
    Top Bottom