momomoey
New Member
Finally gotten around to modifying the back end , but with few tools and diddy rusty vice so tried it this way . . . . .
Yep, bullet indicators, smaller reg plate, and twin rear light from 'ebay'
All bits from 'wilko' store included bag of nuts/washers/bolts, cable ties, cycle innertube, metal gate hinges ! and thin fixing plates as holes already there, and were easy to drill and hack saw
Tap washers and extra metal washers used to mount the indicators
Cut off and re-used existing electrical connectors
Has turned out robust enough, prob will replace the plastic lunch box at some point tho !
Holes also already in ace frame cross member at rear, so easy to bolt the hinges into position along with the fixing plates
Marked were cutting required and then bent whole thing in vice with a little persuasion
Two holes required to mount the light/reg holder
Looks better ???
Yep, bullet indicators, smaller reg plate, and twin rear light from 'ebay'
All bits from 'wilko' store included bag of nuts/washers/bolts, cable ties, cycle innertube, metal gate hinges ! and thin fixing plates as holes already there, and were easy to drill and hack saw
Tap washers and extra metal washers used to mount the indicators
Cut off and re-used existing electrical connectors
Has turned out robust enough, prob will replace the plastic lunch box at some point tho !
Holes also already in ace frame cross member at rear, so easy to bolt the hinges into position along with the fixing plates
Marked were cutting required and then bent whole thing in vice with a little persuasion
Two holes required to mount the light/reg holder
Looks better ???