So I have a hub, spokes and nipples that I want to have powder coated. I would prefer to have it done before the wheel is assembled, but not sure what the best route would be. I was thinking that I would screw the nipples on the threads of the spokes so as to serve as a masking for the threads.
Does anyone have any ideas? Does the powder typically make the spokes too thick to slide through the holes in the hub.
Any suggestions would be greatly appreciated.
Thanks, Ryan
Does anyone have any ideas? Does the powder typically make the spokes too thick to slide through the holes in the hub.
Any suggestions would be greatly appreciated.
Thanks, Ryan