Hey guys!
I finally put my RD 250 Motor together,clutch installed everything works,shifts trough the gears,turns over but suddenly THIS.
the motor did not run yet...carbs are at cleaning now.
yesterday i saw an oil leak on the right motor side coming from the kicksstarter,the motor just got overhauled by myself,new seals gaskets new pistons,et cetera.
is it possible that i forgot the oil seal on the outside of the shaft for the kickstarter,there is an "immersion" on the outside of the motorcover...so did i forget the oil seal on the outside or is there one on the inside too?
the diagram (NO 9) shows an oil seal but does not say where it goes...
i used 1,7 L of gear oil,since my manual says when new clutch plates are installed there should be this much (normally 1,5L) so maybe the motor is too much filled up.
help please...
I finally put my RD 250 Motor together,clutch installed everything works,shifts trough the gears,turns over but suddenly THIS.
the motor did not run yet...carbs are at cleaning now.
yesterday i saw an oil leak on the right motor side coming from the kicksstarter,the motor just got overhauled by myself,new seals gaskets new pistons,et cetera.
is it possible that i forgot the oil seal on the outside of the shaft for the kickstarter,there is an "immersion" on the outside of the motorcover...so did i forget the oil seal on the outside or is there one on the inside too?
the diagram (NO 9) shows an oil seal but does not say where it goes...
i used 1,7 L of gear oil,since my manual says when new clutch plates are installed there should be this much (normally 1,5L) so maybe the motor is too much filled up.
help please...