CB1100F

[J-Rod10]

Shock mount tacked in. Bit of bracing to sort, and the major welding shall be done.

 

[Hurco550]

looking good man!

 

[Maritime]

Slick

 

[cb250nproject]

Sick build


Sent from my iPhone using DO THE TON

 

[J-Rod10]

I should have measured for the offset sprocket I needed before I pulled the engine, but, I didn't.

So, here we are. Going to do that when I have time one day this week, then back out with the engine and on a bench for a week or so to rebuild/paint.

Looks like a motorcycle for the moment, though!

Sent from my Pixel 3 XL using Tapatalk

 

[canyoncarver]

Yes it does!

 

[Deviant1]

Looks like an awesome motorcycle!

 

[J-Rod10]

Time has been short. With the recent cancellation, and rescheduling of MotoGP, I should have no issue getting this done by it.

Removed the front tank mounts this morning, and built some new ones. Back 1", down .500". Gives me the much needed clearance I need for the top triple to move a bit. Now, I need to build a top clamp for it.

Sent from my Pixel 3 XL using Tapatalk

 

[CarbsAndCylinders]

Man, I wish I had your skills.

 

[Maritime]

So awesome

 

[J-Rod10]

Rear set brackets made today. Working on grafting a master cylinder mount to them now.

Need to get a new pivot bolt made as well, and get the mile long stocker out of my way.

Sent from my Pixel 3 XL using Tapatalk

 

[J-Rod10]

Got a bracket roughed out for the master.

Roughed that out on the rotary table, eyeballing tapers. But it let me see what I needed to see.

I'll knock out a nice one now.

Sent from my Pixel 3 XL using Tapatalk

 

[Out]

Looking good. That is going to be an awesome machine.

 

[cb250nproject]

Looks mean


Sent from my iPhone using DO THE TON

 

[AgentX]

Mmmmmmmmmmm.

 

[CarbsAndCylinders]

That looks very cool!

 

[J-Rod10]

Was making spacers for the rear sets, figured I'd go ahead and knock out a new set of bushings for the shock. It was missing a couple when I got it.

Sent from my Pixel 3 XL using Tapatalk

 

[J-Rod10]

Rear set brackets are wrapped up and on.

I can live with these.

Got the brake side sorted first, and the additional mount welded on, and that side bolted on solid.

Ran an alignment rod from that side to the shift side so they were lined up at the same angle/height, and welded in the lower mount on the shift side.

Bit more time than I intended to spend on this, but, it's done.

Sent from my Pixel 3 XL using Tapatalk

 

[J-Rod10]

I can live with that.

Sent from my Pixel 3 XL using Tapatalk

 

[CarbsAndCylinders]

Shock mount tacked in. Bit of bracing to sort, and the major welding shall be done. View attachment 220929

Looking good, that's the cat's ass!