Recent content by Bakerm47

You do not need to remove those screws to split the case. I remove the oil pump after a split the case. That way the flat side of the case can be set on a piece of soft wood and it will not damage the matting surface. BTW the screws are not a standard phillips head, they are JIS, order a set of...

I've done this on my bike. It is a direct bolt on mod, you will need a right side cover, from an engine that came with a tach, and the oil pump assembly. It is just a matter of swapping the parts out. Be sure to replace the o-rings between the oil pump body and the engine case, and use a new...

I am currently building a mild CB350 engine. My current build plan is to use wiseco 66mm 10.5:1 compression pistons and a megacycle 123-20 cam from bore-tech, along with a mild porting on the head. I have replaced my stock valve guides with a set of bronze guides from Schumann Motor Works. In...

I've registered two bikes in alabama without titles, if there over 30 years old all that is needed is a bill of sale. I would have the vin's ran to check there status.