Latest activity

  • JerryAssburger
    JerryAssburger replied to the thread Jerry's Follies.
    So I've been a bit lazy but not much to post.... Tried to change my own tire; the success was subdued by the sound of rapidly escaping...
    • IMG_20230217_152824340.jpg
  • Tim
    Tim replied to the thread The 'leftovers' project - XS650.
    Couple of small bits done over the weekend. Throttle/carbs all sorted. Took some fiddling and deleting of some adjustment to allow...
    • IMG_0463.jpeg
  • Tim
    Could have chosen any 4 letters it seems. I just kept it simple and went with the same method MTO seems to apply to other makes - HOND...
  • doc_rot
    doc_rot replied to the thread V Star 650.
    I did the same test with the belly pan i put on my GSXR, you have more room than i do. Also that is ton of snow on the ground still!
  • sandmanred
    sandmanred replied to the thread V Star 650.
    I found that boots that fit on the shift linkage also will fit on the rod end bearings I used on the brake arm stay
  • Tanshanomi
    Tanshanomi replied to the thread Sr250 carb swap out.
    The thing to remember is that slide carbs flow more than a CV of similar nominal diameter. A Mikuni VM30 or Keihin PE30 would be ideal...
  • pidjones
    pidjones replied to the thread pidjones '72 T150V rescue.
    Doctor sez good news on the knee - no meniscus damage. It is deteriorating cartilage (arthritis) . Just do at-home PT and take...
  • pidjones
    pidjones replied to the thread V Star 650.
    PLENTY to spare!
  • sandmanred
    sandmanred replied to the thread V Star 650.
    Test today to see if I can get down the driveway without scraping the tail.
  • Bevelheadmhr
    Yes, I have used Spraymax 2K before, I was impressed. I will rub down the paint around the filler cap to fade it into the hole, before I...
  • pidjones
    pidjones replied to the thread The Free Kawasaki Z650 Project.
    I love that red! I wait minimum 2 weeks with the bits in my upstairs den (warmest room in the house) before clear with SprayMax 2k. I...
  • Bevelheadmhr
    The new alloy rims have have finally arrived from Italy, and have now been laced and trued, next have to grind down any spokes which...
  • pidjones
    So, you could have chosen VUDU? Glad you have that wrapped up, now. Some places it just involves a few hoops. Apparently, in some places...
  • Rider52
    Rider52 replied to the thread pidjones '72 T150V rescue.
    Looks ready to go!
  • doc_rot
    doc_rot replied to the thread pidjones '72 T150V rescue.
    Looks awesome. Nice work!
Top Bottom