Recent content by bydgoszcz

I know, or at least I think I did, I came across a post that CrazyPJ said he used the Mikuni specific CB350 carb boots on a CB360 because they seal properly. I've searched and searched.... Is this true? Do they fit? Just want to make sure before I order them. Thanks for the help.

Also Sonreir sells some great batteries.... ;)

Does anybody have an idea what the size of the bolts/screws that hold the points to the contact plate? I know the two bigger bolts that hold the contact plate in place are 6x12 but I can't find what the points screws are?

They're a shorter heavy duty shock meant for a heavier CB750, the limited test ride I went on it never hit the seat pan.

The suspension is a little stiff in the back so we'll see if it hits or not. But I'll probably need to lose some weight, ha.

Yeah I know the lithium batteries can be questionable on these little bikes. That's one reason why I went with the EarthX battery, over and under charge protection, should keep me from blowing it up. I think Sparkmoto is selling them now.

Thanks man, It's a Dimecity seat.

Thanks guys!

Well this question is back from the dead. I took apart the advancer on my CB360 yesterday and now I'm having a hell of a time getting it timed. Could I have installed the lobe, weights the wrong way? I see there is a mark but I'm not 100% sure which way it's supposed to line up. Currently it...

Yeah, the tank and rear fender were cleared.

Battery, key switch, starter button, starter solenoid and a turn signal module. The reg/rec I hid away up front on the bike.

Yup, it all comes down to the battery and simplifying the electronics to the minimum. I barely got everything to fit, would have loved if the box was an inch bigger.

Even got out on a first shake down. And yes, terrible orientation.... https://vimeo.com/126316001

I'm actually nearing completion, couple detail items but it's pretty much done.

eBay my friend.