We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
gt alex's latest activity
G
I broke down on my test ride last week
I think I found the problem. I lost the vacuum plug I was using on a T piece on the hose to the...
Jan 9, 2021
G
I spun the carby 180deg now opening towards the rear cylinder and idling at 1400rpm, pulling the front and rear plug both plugs had...
Jan 4, 2021
G
I just fitted a 3/8 id balance tube a fraction larger than the first one and I didn't notice a change but the idle still fluttering on...
Jan 3, 2021
G
I just fitted a balance pipe and although not the magic bullet I hoped for it has defiantly changed things for the better.
I can now get...
Dec 31, 2020
G
It seems the rear cylinder is running lean at low rpm I suspect I its to do with the uneven firing order the air/fuel mix has more time...
Dec 29, 2020
G
after using sealant on everything and putting a temporary deflector under the carb towards the rear still no go but the rear is lean?
Dec 29, 2020
G
Just checked valve clearances right on spec min clearance, ideally I would have liked a couple of thou more but I am ruling that out.
I...
Dec 28, 2020
G
Rear cylinder is still not playing the game. With idle set 2000 rpm It idles 5 seconds then the rear cuts out And runs on the front for...
Dec 26, 2020
G
It handles great the geometry is still conservative when compared to how high racers raise the tail on these bikes. the rear is standard...
Dec 23, 2020
G
We did well, the the water tanks and the dam are full.
Dec 21, 2020
G
I through myself a curve for a couple of days by not pressing to rear of the manifold all the way home. but I should be back on track now.
Dec 21, 2020
G
Success is not guaranteed This is not paint by the numbers. This item was not sold equipped to suit the bike.
These were sold pre setup...
Dec 15, 2020
G
Ok. Time for an update,
If idle speed is correct too much fuel is being delivered thru out the whole range. If I adjust for a 3500 rpm...
Dec 13, 2020
G
My air filter just arrived and I am booked in for dyno tuning 14 Jan 21.
It took a bit to find a dyno operator willing to try something...
Nov 25, 2020