Recent content by Lucas Denton

That sir is an ingenious idea!!!! to bad mine exploded while exiting the swingarm...... I see eBay listings for bronze bushings but they are only for the cb350 and cb500's and so on. Whats the likelihood of them having the correct dimensions?

The needle bearing washers are a very good idea but the only reason I would need those is if the bearings that actually go into the swing arm do not have a collar. The originals had this all in one piece (see link)...

that sounds like a good idea but the original ones fell apart during removal. Could i get the needle rollers and just find some washers the same dimensions as the original collar if they were separate?

I am in the process of replacing the swing arm bushings in my 72 cb175. I'm looking for a bronze alternative if this exists for the pivot bushings. If anyone has any information as to where I can find some please comment. Thanks in advanced! I attached a few pics from a week or so ago.

I wont be putting that one back on without a new pin to put back through. The brake pedal was grown to it and was in the way of my rearsets.

It happened exactly in those steps!! ;D Thanks for the answer!

Anyone have any tricks for getting the center stand off a cb175. Mine will not come off!!!!

Re: Anybody in need of a CB175 (2600 miles) Also just received rear-sets in the mail today for it.

Re: Anybody in need of a CB175 (2600 miles) Make me an offer I cannot refuse! ;D

I have a 1972 cb175 I'm looking to sell, I have found a cl450 that I am interested in and I need to sell this one to make room in the driveway. I'm located just south of Atlanta. I do have the sprocket cover but it wasn't on in pics.

That sounds interesting.

What is needed for installation?

Does anyone happen to know what resistor to use inline for led turn signals?

Would you happen to have any pics or anything of your products?

Thanks for the info about Viet I will PM right away!