Recent content by olds-cool

No problem, thanks anyways

Do you have the ignition switch and seat lock with keys?

Yep, the CBR tail is huge. It needed about 2 inches taken out of the middle to fit right. Buddy wanted $75 for it and it was too much to spend for me to F up so I found the R1 tail for less than $30. No worries about cutting it in half now. It will work out well when I'm done with it. I can...

2 more pics

Hey fellas, haven't been over here in a while. Got an email about some site changes and thought I'd check them out. Since I'm here, may as well share what I've been doing on my fighter. It's not your typical fighter per say since it's a '72 CB500 but it doesn't really fit into the cafe dept...

These are nice quality bars. I just got my set last week from another member. They're worth what he's asking. Have you seen the Ebay price on these?

Zixxerboy, you finally found a use for MC Hammers old pants! Seriously though, did you cover the fabric with fiberglass resin? I could see some uses for that in a slightly less flamboyant fabric.

Re: FS: 35mm clip-ons!! Update: These are sold. I bought them over on SOHC4 ;)

I've never shipped anything like that so I have no idea what the best or cheapest way is.

Where'd those rearsets come from?

I like your tank. What process did you use to stretch it?

Looks good man! Just like everyone else, I love Benjis stuff just not the prices. Looking forward to finished pics with the sidecovers. Any engine mods to go with the sweet looks?

Boss said today that our bonuses should come in on the 3rd week of Feb (I've been waiting forever). Come up with a ballpark price for the whole front and if you still have them when the check gets here, we'll haggle. Where abouts are you? Shipping might be a pain in the ass.

Oh and for anyone who is looking for a metal source, the prices on http://www.metalsdepot.com/ are just a little bit cheaper than what I paid. Nice selection too. I haven't ordered anything from them though so buyer beware.

Pre-polished?? ::) More like pre-scratched. I was a little disappointed but no big deal. I scratched it even more when cutting. It cuts easier than the steel plate but still fairly hard to get through with a jigsaw. I got the shifter side cut out last night. Now I have to do some...