Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I am in need of 2 inner valve springs for a cb/cl/sl 350 motor, part number 14761-286-020. I want to find NOS parts. Help me finish my engine build.
Mike
These idiots (mechanics) are completely out of ideas, I'm picking the bike up probably tomorrow (assuming it isn't raining that bad.
First thing I'll do is pull off the air filters and check the carbs with my volumeter (air flow meter?). I hope it's that simple, otherwise the next move is to...
Is it possible that the thicker JBM diaphragms are responsible?
Seems pretty likely I'm going to be pulling it from the shop. They don't know what's up, and wouldn't want to open the engine till November. Apparently the loss of power issue is still very real, and I would have to tow it from...
Sorry for the delay, here's an update:
The spark advancer seems to have improved the issue, but not fixed it.
Current major issue is that the throttle 'hangs' aka the RPM's don't drop when you let off the gas. It's an issue I've had since I've had it, but not one I've considered to be the...
The brass is pieced together from 2 kits (Sirius and DCC). As far as I know, the main and slow jets are in the right spot, I doubt the shop would have messed that up, this isn't their first CB/CL. The slides are definitely fine, I have lubed them and checked for smoothness (before and after...
Warm, the bike has compression of 165-170psi. I adjusted the valves this winter, they should still be in spec.
The timing is on at idle, but the bike will not rev to 4k RPM.
The shop just went through both carbs. Replaced both bodies, I used all new brass internals, which were transferred...
Hey guys,
I decided to make a new post for my ’70 Honda CL350 K2 Scrambler, as the other thread was months old and over 10 pages long.
After putting in ~6 months of blood, sweat, and tears into this thing, I dropped it off with a mechanic. I haven't been able to get the bike running for more...
Devil bike is back >:(
I noticed that the bike started missing on the right side more and more. I retimed it (it was in spec), gapped the points (.014 and .013), and gapped the plugs (.028), but it had no effect. I put in a new plug on the right side. The bike then rode fine for about a...
Turbo CB750 anyone?
http://chicago.craigslist.org/nwc/mcy/4491506451.html
I really like this: Yamaha 200 CS5. Very clean
http://chicago.craigslist.org/nch/mcy/4494937633.html
Any ideas on where I can find pilots in those sizes? My google searches for "keihin 3d" or "honda cl/cb" turn up negative for anything other than 35 and 38.
Yep, as far as I can tell, 35 is the smallest in existance.
Ran the bike for a few hours this weekend. The throttle really crisps up when I set the mixture screw to 1/4 turns out. Obviously to lean this thing out a bit. I'm wondering what jet I need to replace as the naming conventions are a bit vague. Tell me if I'm wrong here, but I should swap out...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.