Search results

I have some remaining parts that I would like to get out of the house soon. - handlebars with original grips, controls (need to be gone through), clutch lever -engine case from torn apart engine -engine (locked) without oil pump and Pistons -front fender -tailpiece with light -chain guard...

The only other thing I have not done was try a new battery

I have a a 1993 FZR 600 what measurements do you need if you still need them?

Rebuilt the carbs before it started running bad then I rebuilt them again thinking something got through the fuel filter causing it to run bad; however that was not the case

Also carbs were freshly rebuilt

it's a direct line to the carbs and I know it is getting plenty of gas. So I know fuel starvation isn't the problem it just runs similar to that :-\

Hello Guys, I have built a cafe bike out of my KZ 55O about a year ago. About 3 months ago my bike has started acting up. The bike runs and idles, and when you lay on the throttle it revs to red line. However when you put it in gear and start moving it starts acting like it has fuel starvation...

Please let me know if you have a titled frame for a kz650 or a kz550A.

I just picked this up and can someone tell me what year this is? I was thinking 1978

A little update for everyone. Finally was able to get back in the shop and starting mocking up the bike. Not sure yet how I want the back end to work.

Due to work schedule and Ohio's fantastic weather, I have not been able to go any further on the bike. However picked up a set of these nasty GSXR forks to change up the front end. Once I get it back in the shop. I plan on mocking the bike up and see how much clearance I have with this front end.

Hope to join you guys. I'm from the Westerville area and hope my Brat kz550 will be reassembled by then.

Well I did some revision on the sketch as I still wasn't happy with where it was going. Here is the final sketch but I am probably going to change the tailpiece to more sleaker look. I'll be starting next week after I get back from vacation.

Luckily working with family friend who does fabrication and welding so their won't be much of a problem with any fab work that needs to be done. Just wanted to do a updated twist on an 80's bike. Not a fan at all with CV carbs, regardless they have been giving me problems and rather go with the...

I'll make sure ill do that once I start the tail piece! So I put some finishing touches on the sketch. Everything is not set in stone yet but liking it so far. Next thing can someone tell me if I can get rid of those awful CV carbs and go with mechanical sliders that are on the KZ550?

I used the original GPZ wheel for my other bike and threw this junk LTD just to have a rolling frame. Plan on using the the rear FZR rim and the FZR swingarm. Hope to start soon. Here is my initial sketch for the bike.

Anyways started stripping the bike for fabrication and dropped the frontend of a fzr 600 into the frame. My surprise it dropped right in with no work necessary. Also managed to get a pair of Woodcraft rear sets for a zx6 off craigslist and hope to started fabing the frame soon.

Started tearing down the bike today. Was trying to figure out why the bike wasn't firing. I was getting good compression in all four cylinders, spark from both coils and it was turning over with ease. Took the top end off and don't see any signs of scaring from the pistons or anything out of the...

Just wanted to start off with saying I'm new to the forum and after months of procrastinating decided to create an account. Always big into old school bikes and especially the cafe racers. This summer I picked up a KZ550 ltd from a family friend. I wanted to create more of a "cafe/rat" bike and...