Search results

What types of hardware have folks used to attach seat pan to frame? I was thinking of fabbing up some kick plate style sprint clamps and weld underneath the pan and then weld some round stock to the top of my electronics tray that the spring clip would clip onto. Other ideas? Sent from my...

Love it. Don’t apologize for the length - this is fascinating to watch! Kinda like a tinkering/wrench version of Slow TV. Sent from my iPhone using Tapatalk

Ok good call on high density foam. Original reason for cutting down foam is so I could use stock seat pan and not have to fabricate something custom, but I’ll take this as an opportunity to learn. Sent from my iPhone using Tapatalk

Yea I found the bottom ring on left piston snapped in half when I took the block off. Not sure if that was the cause or not. Compression was excellent in both cylinders before disassembly. The block is now at my machinist getting bored out to 69mm for the gs850 pistons. He estimates 3 or 4 weeks...

Just picked up a ‘76 CB360T. It was 22,000 miles but is all in stock condition and I do not believe the engine has ever been rebuilt. It runs but something doesn’t quite sound right and I believe there is a slight knock in the left cylinder. Haven’t measured compression yet. Even so, I’m...